[doktorabg]

From 2010 BMW use pin 8 for Ethernet therefor you need switch between pin 7 and pin 8 like Catana said.
For E series use dcan utility but for F series is better to use Ethernet to OBD 16 pin (cable for E-SYS) with ISTA-D/P

2/2007 and older vehicles requires the pin 7 and 8 to be bridged!!

You must bridge or not 7 & 8 pins, like in picture attached

Up to 2010 the easy way is to bridge.
From 3.2007 use DCAN Utility.
From 2010 not use the bridge ,use only pin 7 because pin 8 is for Ethernet and therefore comes problem with communikation with car.
CAN L and H are still on pin 6,14 and therefore use DCAN utility to change the speed.