[benyclaudiu]

1) Introduction:

There are several different hardware models Becker MAP PILOT:
Earlier release, such as:

9077, M013, M041, M045, M046, M050 and M051

and new models, such as:

M054, M075, M076, M083, M084, M085, M092 and M097

In addition, there are also other models, destined for the foreign market, such as:

M052

Updates will run on older models of BMP with 4GB memory (with the installation of an SD card) or 8GB

For the new model updates are not yet ready and processed, incl., Will be made soon.

2) Important! Installing the firmware:

Those who have already put the previous version v.10 with replacement firmware (Firmware) on "R22.3.1205", you can skip this step and proceed with the installation v.11

Before replacing the firmware (Firmware) of your model "R22.3.1205" (without updating it will not work!), Make a backup using BCM (Becker Conect Manager), which is set by connecting to your computer BMP, there, at the bottom, you you can learn and the number of your original firmware.
Then we delete all data from the BMP.

Download the file Image 22,31205

and unpack it in a pre-created folder, as you would call it all the same, for example: "Firmware". There will be 3 files: "iboot.exe", "WINCEIMG.BIN" and "WINCEIMG.CKS", which is copied directly to the BMP (but not the folder!), And then disconnect the (necessarily in safe mode!) From the computer and do rezet using, for example, a ballpoint pen, by pressing during 10 sec. on the reset button on the device.
I advise to wait an additional 10 minutes to initialize the file, then you can connect to a computer over BMP.

For the new models of the firmware here:

Download the file Image 21,0,0528

ap at the end rename to zip., but again, for them more work is done!

3) Installing v.11:

After downloading all the ports and unpacking, copy the files completely and without any changes! , On BMP (after erasing all files in it). Copying may take several minutes, in any case, wait until the end, and then disable (in a safe way) from the computer and try the device on the car.

Suitable for radio and Audio20 Audio15 and the following car brands:

Audio20:

W / S204 Mopf (ab 03/2011) R172 (ab 03/2011) C204 (ab 06/2011) W246 (ab 11/2011) W166 (ab 11/2011) X204 Mopf (ab 06/2012) W / S212 ( ab 06/2012) A / C207 (ab 06/2012) C218 (ab 06/2012) W176 (ab 09/2012) C117 (ab 04/2013) X156 (ab 03/2014) ff. (Alle NTG4.5 BR auYaer R231)

Audio15:

C906 Mopf (ab 09/2013) VS20 (ab 11/14)

P.S.:Eschё one point from the backup I copied to the BMP, as the addition of 2 file: DRM and DumpFiles, although I do not know you need it or not