[bibigor]

Hi guys,

I made a small utility suite which allows manual control of voltages which Ediabas sees from the interface such as OBD or CAN. It also includes additional ISTA+ support so it should work with ISTA as well. It's not dependent on INPA or ISTA versions and should work with any version of INPA, ISTA+ and others as well as it integrates between ediabas and cable driver and is completely transparent to high level software. Additional support for ISTA+ should work with any modern version as long as internal code will not change much. My aim is to make it so all ABLs and other procedures work flawlessly.

The link to the suite below

Installation instructions:
1. If you are using STD:OBD rename existing obd32.dll to obd32.ebas.dll within Ediabas\Bin folder. For INPA its in C:\Ediabas\Bin, for ISTA+ its in Ediabas\Bin within ISTA+ folder. STD:CAN users do the same with can32.dll -> can32.ebas.dll. I do not have any CAN cable to test myself, so its not tested though.
2. Extract the zip file.
3. Rename NodeEdiabasVoltageControlDll.dll to obd32.dll or can32.dll respectively and copy it to Ediabas\Bin.
UPDATE:
4. Additional step for ISTA+ support only: copy included NodeISTAVoltageControl.dll to Ediabas\Bin folder within ISTA+ installation.

Then enjoy the results: to control voltage run the exe from zip which can be placed anywhere you want. If exe application is not started, this software becomes completely transparent and does not influence any readings at all.

System requirements: Visual Studio 2015 x86 runtime must be installed (same as required for last versions of ISTA+).

P.S. This is the second release now so please still report any bugs. I've tested it as much as I could but I use ICOM myself, so this was more of a curiosity project for me.

P.P.S. This voltage control utility is not designed to and will not work for ICOM users.

The link to downloading does not work, update please. Thanks.