Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Programming fails on a "EKB945 DME" with Ista-P
02-12-2017, 08:53 AM,
Post: #1
|
|||
|
|||
Programming fails on a "EKB945 DME" with Ista-P
HI all.
a few days ago ive tried to flash a EKB945 DME on a 2004 BMW 116i. everything went ok until about 16% and then ista-p came up with this error: (global vehicle communication coapi 2084, sys 008 job not found, job identification in groupfile not ok, flash identification ediabas98. ive tried several times to program again with ista-p but didnt worked. then i triedseveral times to flash with WINkfp but that also didnt worked. you can see the screenshots in the pics. Ista-P says the Dme needs to be replaced so i bought a new one and tried to program it with ista-p. i was shocked when the same fault occurred again. when programming the new one ista ask for the programmed dme part number and ive tried all the numbers on the new and the old dme. also the number given from etk. ista accepted the numbers but programming keeps resulting in failure.... can someone please tell me what to do because i ran out of luck and ideas for now. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
2 Guest(s)
2 Guest(s)
Return to TopReturn to Content