[donke]

coding FEM_BODY module:

3061 NSW_R_KALTUEBERWACHUNG -> nicht_aktiv : Disabling cold check for Front Right Fog Light.
3061 NSW_R_WARMUEBERWACHUNG -> nicht_aktiv : Disabling warm check for Front Right Fog Light.
3061 NSW_R_IS_LED -> aktiv : Setting Front Right Fog type to LED.

3061 NSW_L_KALTUEBERWACHUNG -> nicht_aktiv : Disabling cold check for Front Left Fog Light.
3061 NSW_L_WARMUEBERWACHUNG -> nicht_aktiv : Disabling warm check for Front Left Fog Light.
3061 NSW_L_IS_LED -> aktiv : Setting Front Left Fog type to LED.

I've had the same problems with the flickering LEDs after two minutes, when I'm using the corner lights, so when the steering wheel was not in the correct middle position.
For this, please add the following codings:

3061 NSW_R_UE_SPG_SCHUTZ -> dimmed
3062 MAPPING_ABBIEGEL_R_PWM_LEVEL_1 -> 100%
3063 MAPPING_NEBELSCHW_R_PWM_LEVEL__1 -> 100%
and of course for the left side:
3061 NSW_L_UE_SPG_SCHUTZ -> dimmed
3062 MAPPING_ABBIEGEL_L_PWM_LEVEL_1 -> 100%
3063 MAPPING_NEBELSCHW_L_PWM_LEVEL__1 -> 100%

Since this codings the fog lights will work as expected

---

Try updating FEM and add 5A1 to VO and code it.

Thanks, the VO coding was the one missing point for my car. So I can now add this to my car, too and I will be on the save side, if the car will get an update by an inspection ...