[premium89]

I can confirm with my own experience, that kess 5.017 and ktag 7.020 clones are very good tools! You can use every protocol listed in 2.47 for kess and 2.25 in ktag, every job until now done! There was only once an issue, when i did audi s8 med9.1 master/slave, it doesn‘t finish programing because of wrong file size, but any ecu else will be done.
This cp45 will be done for sure, but the real risk is opening that sort of ecu.
That’s why you need genuine tools with bench function, which is working aswell on tricky edc16 ecus like edc16cp31.
But i will say, it is good to have also the clone tools, i had weird situations, for example audi edc16cp34, flex and autotuner fails to write second section, kess did it without problems….