[ka_rai]

hi friends

where you found good jlink to flash nxp ? (ebay 10€ ?)

my pcb is EU clone, maybe i can rewrite fw in nxp without change NXP using jlink ?
seem very difficult remove nxp .... ?

thanks for your help

[ltujustas]

You can with cp2102 rewrite fw if nxp doesn't have crp3. If crp1 or crp2 you can rewrite the same fw with usb to ttl only.

CRP1 disables access to chip via the JTAG and allows partial flash update (excluding
flash sector 0) using a limited set of the ISP commands. This mode is useful when CRP is
required and flash field updates are needed but all sectors can not be erased.
CRP2 disables access to chip via the JTAG and only allows full flash erase and update
using a reduced set of the ISP commands.
Running an application with level CRP3 selected fully disables any access to chip via the
JTAG pins and the ISP. This mode effectively disables ISP override using P2[10] pin, too.
It is up to the user’s application to provide (if needed) flash update mechanism using IAP
calls or a call to reinvoke the ISP command to enable flash update via UART0.

[ka_rai]

thanks friend for your help

nobody have service to unsolder NXP ? (using good tools and good way )

[domelec]

thanks friend for your help

nobody have service to unsolder NXP ? (using good tools and good way )

look in selling section
there used to be a few people there offering nxp replacement