[Big Tom]

Hi all,

Can anyone advise how to remove, or if its possible to remove the immo from a 2007 Fiat Bravo 1.9 jtd, fitted with a Bosch ECU part no 0 281 013 579. Can anyone also advise type and location of the correct eprom/mcu to find the information and which tool is best used for this job. This is driving me up the wall we have replaced the bsi with a used unit and can extract the code but we should have replaced the full system. The dealers want mad money and the end user does not want to pay high prices. we have so much time and effort in this we just want to get the car started. Any help or advice is appreciated.

[dvdpgn]

Hello, you have to read the FLASH with galletto or kess etc ...
Program FLASH

Calculate the checksum before programming the Flash

Communication Line K
Connector right
Pin K4 = -12V
Pin K1 = + 12V
Pin K5 = + 12V
Pin K25 = K line

[Big Tom]

I am fairly new to this game can you advise chip type and location either in the bsi or ecu? I have Mtrk, Ultra prog, and Carprog readers, which would be best?

Thanks for the advice

[Abou-raffik]

I am fairly new to this game can you advise chip type and location either in the bsi or ecu? I have Mtrk, Ultra prog, and Carprog readers, which would be best?

Thanks for the advice

dvdpgn mean ecu flash for immo not bsi

for chip must be 29f400

[Big Tom]

I have opened the ecu and cannot see any chips with this identification is there another number?

[bogdanwmw]

Ecu is edc15c7? read 29f400 and post. exist solution for immo off and dtc delete. u1600.

[Big Tom]

Problem now solved replaced full kit appologies for answering in the other thread was in a bit of a hurry at the time. thanks to all that helped