[ir0n87]

Made a lot and lot of tests...
China or carsystems emulator got same behaviour... Randomly reboots. So it's not a emulator issue.

My evo was flashed with 59.5 using tal calculation with G11.
Now with psdzdata v60 and culculating tal with F20 (bootloader and swfl goes from v3 to v5) never get anny reboots from weeks!

Bye

[simonchs]

Made a lot and lot of tests...
China or carsystems emulator got same behaviour... Randomly reboots. So it's not a emulator issue.

My evo was flashed with 59.5 using tal calculation with G11.
Now with psdzdata v60 and culculating tal with F20 (bootloader and swfl goes from v3 to v5) never get anny reboots from weeks!

Bye

Flash with modify production date to 0716 or 1116? Or it’s doesn’t matter?

[ir0n87]

I use 07/16 with V60 F20 psdzdata... U will see tal calculation will generate a v5 btld and v5 swfl.
With v5 never get any reboots!

Bye

[chriscom]

Where you get the Evo's with HW 2 upwards?

[ir0n87]

NBT evo F20 chines emulator same thing, NBT f13 carsystems emulator badly freeze controller and display until resetting kl15.

Please cut pin14 from quadlock... NBT EVO make a short to GND in pin14 if connected to dimmer line!

Bye!

[ir0n87]

Mine have 2.3, it was wrong what I wrote in my first post.

For all with this issue:
I keept searching a long time and it seems up to HW2.8 they only have 4GB RAM like shawnsheridan wrote and so with the ID5 or ID6 it´s less RAM to use it with all functions. "card zoom" sems to be a function what is very RAm hungry, in our F11 it is disabled and it only resets once in 2-3 weeks and in the F22, where it is enabled, it is resetting once in a hour. Now we try this function disabled in the F22 and I will give feedback.

Any news? What do u mean for "card zoom"?

Bye

[masa52]

Hi

sorry could someone give me advice as I bought used CID for NBT EVO from F06
tried connect to my car which has factory fitted NBT but cid dont work error no signal and horizontal line displayed
Is it normal need nbt evo unit or it should work on old nbt as well
please let me know but if it should work I'll refund it

thanks

[840i]

Hi

sorry could someone give me advice as I bought used CID for NBT EVO from F06
tried connect to my car which has factory fitted NBT but cid dont work error no signal and horizontal line displayed
Is it normal need nbt evo unit or it should work on old nbt as well
please let me know but if it should work I'll refund it

thanks

Since you are using normal NBT and EVO screen, in order for the EVO screen to work, you need to flash your NBT with newer firmware and then it will work. I did pszdata 58 before and it worked just fine after that.

[masa52]

Got latest software in NBT heard that in f10, f06 screen wont work very often even that latest software on it

thanks

[BaggieMatt]

I would be seriously concerned about that vertical line. I would say that as it is not detecting a signal then that line is not being produced by the NBT and is therefore a failure of the screen.