[pullesnoter]

Hello,
We replace the i-drive screen and ccc. now i have to recoding this modules. my question is , is it good to program this with ista-p?

grz

[raduandrei82]

You can do that, and when it asks you if you replaced an ECU click yes. It will create the measure plan accordingly. Otherwise, you can code it with NCS expert.

[pullesnoter]

You can do that, and when it asks you if you replaced an ECU click yes. It will create the measure plan accordingly. Otherwise, you can code it with NCS expert.

if i use ista/p, i not need speciale codes to reprogram this modules?

[raduandrei82]

You can do that, and when it asks you if you replaced an ECU click yes. It will create the measure plan accordingly. Otherwise, you can code it with NCS expert.

if i use ista/p, i not need speciale codes to reprogram this modules?

You will need the FSC repair pack for your VIN, as the new unit won't have them.

[gvitkis]

You can do that, and when it asks you if you replaced an ECU click yes. It will create the measure plan accordingly. Otherwise, you can code it with NCS expert.

if i use ista/p, i not need speciale codes to reprogram this modules?

did you install NCS?

[jaki]

I strongly recomment to code it with NCS Expert. With Ista/p it probable wants to flash whole car at a same time. With NCS You can code it in seconds..or at least in in one minute.

[pullesnoter]

I strongly recomment to code it with NCS Expert. With Ista/p it probable wants to flash whole car at a same time. With NCS You can code it in seconds..or at least in in one minute.

i have ncs expert but not so mutch experience with this. can you give me some tips?
i need with ncs olso this repair pack?

[gvitkis]

I strongly recomment to code it with NCS Expert. With Ista/p it probable wants to flash whole car at a same time. With NCS You can code it in seconds..or at least in in one minute.

i have ncs expert but not so mutch experience with this. can you give me some tips?
i need with ncs olso this repair pack?

I can help, seeds from access with teamviewer

[pullesnoter]

I program it with ncs. its works. Only the nav module (ccc/capp),is not visible in ncs to program.
how can i add this?
in INPA is the nav module ok.

grz

[TomoR]

You dont have CAPPL...this is business navi and on NCS there is only 1 module....MASK!!