[zmann]

Hi, Check ECU> Standard parameter> Immo status and post what it says

[CHIKODIAG]

HI
it say ecu is loked and the ecu wait the pin from the bsi
i have check the can line from bsi to abs and from abs to ecu is good
i have try with 2 bsi the saime resolt and i have try with new bcm (+B/+AA)

[dell66]

CODE PIN = C3LX

Hello
1 your epp virgin
2 your MPC off

1 is what the pin code you have and the same
otherwise write blank and Diagbox coding
2 at worst off on MPC

[CHIKODIAG]

GOOD MORNING
ok so yesterday i have done same resarche for a new ecu in mi aera with no luck to find a replecment ecu
whene i come back to the workshop i get mi diagbox and a idea so i connect the ecu to the car and slide a twizer on ecu conecter pin and up the ecu is INLOKED the car ran like charme i wait same time and turne off the car turne on and the ecu is LOKED
this ecu have a can fault in hw or sw i dont know i will keep working and give the news
THANKS FOR YOUR HELP AND TIME

[zmann]

HI
it say ecu is loked and the ecu wait the pin from the bsi
i have check the can line from bsi to abs and from abs to ecu is good

Don't know how you checked the CAN. May try to check again by my step...
1. disconnect battery
2. BSI, ABS, auto transmission (if applicable) and ECU in place
3. Ohm meter measure to OBD connector between pin 6 and 14 (ISO CANH & CANL), you must get 60 - 62 Ohm
4. remove BSI and measure again, now must get 120 - 124 Ohm

[CHIKODIAG]

HI
the news is very good i solve the problem
the problem is in ecu flash i have fonde a virgine file for the flash warit to the ecu keppe the org eprom and go to the car i have to do same reconfigiraton and hop the car start the fault baybay
@MR:ZMANN it is the saime think i do and in this car i go fare and check wairings one by one
@MRELL i have not test your file but the next one i will report
thanks for evry one one by one it is time to get same

[ROD-BENDERS]

HI
the news is very good i solve the problem
the problem is in ecu flash i have fonde a virgine file for the flash warit to the ecu keppe the org eprom and go to the car i have to do same reconfigiraton and hop the car start the fault baybay
@MR:ZMANN it is the saime think i do and in this car i go fare and check wairings one by one
@MRELL i have not test your file but the next one i will report
thanks for evry one one by one it is time to get same

Chiko can you post up the virgin file please ?

[CHIKODIAG]

HI HERE IT IS
GOOD LUCK