[MARTINS AUTOMECH]

AFTER SOME YEARS OF RESEARCH AND MONEY INVESTMENT I HAVE FINALLY COME OUT AGAIN WITH THE FIRST EVER IMMO OFF SOLUTION JUST AS I DID tO MM48P.11 ; NOW I DO FOR PEUGEOT ME7.4.5 ECU THAT, HAS LONG BEEN A PROBLEM WE COULD'NT SOLVE. ANYONE INTERESTED KINDLY PRESS THANKS AND REP THEN REQUEST BY PM. goodluck.
[bNOTE;

after write to 95320 ok. then cut the red line of stater line that goes to the bsm (front engine compactment fuse box) to test first contact the red wire to battery positive it will turn the car and start. test ok get a relay and connect the starter to bypass the connection of the starter to the key fibre in the igintion key [/b]
all THANKS TO KABILLAH a NIGERIAN friend
note; disconnect the key receiver on the ignition so that it doesnt write back code

[dadal]

Tested yesterday, it works 100%
do you have original file of this immooff dump ?
can you share also solution for MM48P.11 ? I do know I ask too much asking=learning
thanks again mate

[MARTINS AUTOMECH]

Tested yesterday, it works 100%
do you have original file of this immooff dump ?
can you share also solution for MM48P.11 ? I do know I ask too much asking=learning
thanks again mate

here
note; write to eprom atmel either 28040 or there abt

[pmazo]

Hi,I hope this works im going to try tommorow i have one with BSI issue

[pmazo]

Tried this today worked 100% thank you very much brilliant work

[dadal]

Tried this today worked 100% thank you very much brilliant work

whichone did you test ? me7.4.5 or 48p.11 ??

[prospeed]

Https://cartechnology.co.uk/showthread.php?tid=28994

here you can find solution for me745
no need to cut any cable
no need to install relay for the starter
program the eeprom and off you go

[actionx]

AFTER SOME YEARS OF RESEARCH AND MONEY INVESTMENT I HAVE FINALLY COME OUT AGAIN WITH THE FIRST EVER IMMO OFF SOLUTION JUST AS I DID tO MM48P.11 ; NOW I DO FOR PEUGEOT ME7.4.5 ECU THAT, HAS LONG BEEN A PROBLEM WE COULD'NT SOLVE. ANYONE INTERESTED KINDLY PRESS THANKS AND REP THEN REQUEST BY PM. goodluck.
[bNOTE;

after write to 95320 ok. then cut the red line of stater line that goes to the bsm (front engine compactment fuse box) to test first contact the red wire to battery positive it will turn the car and start. test ok get a relay and connect the starter to bypass the connection of the starter to the key fibre in the igintion key [/b]
all THANKS TO KABILLAH a NIGERIAN friend
note; disconnect the key receiver on the ignition so that it doesnt write back code

Hi Martins thanks for the file the car is starting but engine check light comes on and gives can communication error u0103 with transmission this car is manual not auto

Any ideas
Regards

[ljscodex]

you can use this soft without cut.
https://cartechnology.co.uk/showthread.php?tid=49363

[actionx]

you can use this soft without cut.
https://cartechnology.co.uk/showthread.php?tid=49363

Thanks that worked for me