[mrtylmz]

Hello everyone,

I have a 2003 Peugeot 1.4 Hdi, if I were to send you eeprom crash data could you clear and send it to me again?

Thanks in advance.

[CHIKODIAG]

HI
if you read and post your file we can clear it for you yes
good luck

[mrtylmz]

HI
if you read and post your file we can clear it for you yes
good luck

Thank you for the reply.

I have just downloaded Airbag Tool program from here, but I do not know where to start. How I establish the connection between airbag module and the program. I can unsolder the Eeprom if needed, but I do not know how to connect it to my computer. Do I need special tools for the connection, I can make electical circuits if needed.

[CHIKODIAG]

HI
what programer you have to read the eprom ?

[mrtylmz]

HI
what programer you have to read the eprom ?

I do not have any program yet, I have found an instruction to read the data but it is for toyota. I do not know whether it works on my car's eeprom.
Here is the instruction
http://www.instructables.com/id/DIY-Rese...rash-Data/

If it is not possible via this instruction, could you advise me to find an affordable way to read eeprom data.

[CHIKODIAG]

HI it work like that
1/finde/ open/ desolder the eprom (if mcu you need the jtag or bdm conection)
2/use a programer x-prog / beeprog/ mineprog /carprog or............
3/read the chip with the programer and save the file
4/start your clear program (airbag tool ) open the file you have read ant select the information in your soft HW/SW part n car brond ........ and click clear whene it is done save the new file
5/warit the clear to the chip
i hop you get the idia
good luck

[mrtylmz]

HI it work like that
1/finde/ open/ desolder the eprom (if mcu you need the jtag or bdm conection)
2/use a programer x-prog / beeprog/ mineprog /carprog or............
3/read the chip with the programer and save the file
4/start your clear program (airbag tool ) open the file you have read ant select the information in your soft HW/SW part n car brond ........ and click clear whene it is done save the new file
5/warit the clear to the chip
i hop you get the idia
good luck

Thank you for clear explanation I completely get the idea but I have a quick question.
Do we have to desolder the eeprom to reset crash data ? or do we have another way?

[CHIKODIAG]

hi
the beter is desolder then read to get a good data read
good luck