[koziol]

Costumer called today that he has CAS2 in boot mode 
 he was doing updates and the process failed 
 now the car does not start no communication with cas is there any solution to bring this back to life ?

[hakank]

I have same problem can you help me.
My Car is a E84. In Inpa/p i was doing flash update an the process failed.
I can´t start the car an have no communication with car

Can you help me?

[Qwerti]

Bridge the terminal30 and 15wup, than flash it again. (key is removed)

[koziol]

what do you mean by Bridge the terminal30 and 15wup?

[Node]

That means take a piece of wire and connect them so CAS gets power and can be re-flashed. This is the official procedure and is described in ISTA-P manuals.

[koziol]

is it possible to do it on bench ?

[Qwerti]

is it possible to do it on bench ?

Yes.

[hakank]

I have access to cas3. I tested wirh winkfp and try to flash. Get a error flash code 211. signature error.
Have you a solution?

[Twoone]

[quote="hakank" pid='405167' dateline='1545857688']
I have access to cas3. I tested wirh winkfp and try to flash. Get a error flash code 211. signature error.
Have you a solution?
[/quote

Did you flash with key not in ignition (KL15 off)

Whitch tool dit you use ICOM or K+DCAN?

Can you still acces the module with Toolset 32?

If you have connection in toolset 32 look programming mode? probarbly 12

If yes try to flash with ICOM and ISTA-P

[hakank]

KL15 is off. I use K+DCAN an have acces with toolset32
The programming mode is 12.
I havent ICOM