[Justgytis]

Hi,  so i had my plcc32 programmer, and i copied files from ecu. Can anyone check if they are fine? My friend having problem after 3k rpm, car cuts out and very hard to start, mechanic find out after cut out alot of air inside fuel system. When car starts it smokes blue for a little bit. Up to 3k rpm all good.

Edit: car vw passat 1.9 tdi, 110hp. 1997.

[Orange_99]

hey mate,

we need an orig file to check!
pls upload this.

[Justgytis]

hey mate,

we need an orig file to check!
pls upload this.

This files are from eeprom.it is older version of edc15 How do i need to get ori file? There's 2 eeproms 27c010 atmel. Thanks

[Orange_99]

you get the ori files only befor write this files.

[loki954]

as i told you before in the other thread the pump voltage map is messed up 

15% up 

turbo map ori..... and so on.... + 60% torque

[Justgytis]

as i told you before in the other thread the pump voltage map is messed up 

15% up 

turbo map ori..... and so on.... + 60% torque

Yea i know, but how to make ori file from bin file? Maybe you can change this file? I have tl866ii+ programmer.  One guy did this remap about 3.5 year ago. I'm new to this stuff, and i have just genuine kessv2 slave

[loki954]

you need new 27c010(OTP) or 29f010 

here is ori file for your car

[Justgytis]

you need new 27c010(OTP) or 29f010 

here is ori file for your car

I already brought at27c010-70ju is it gonna be ok?  You are best mate 

[Justgytis]

you need new 27c010(OTP) or 29f010 

here is ori file for your car

so I write this file in chips, put it in the ecu and in the car, and car looks like have no turbo, scan with deplhi no dtc codes. my friend forget to tell me that him have turbo from pd 130hp engine, and air manifold from pd 130hp. is it that would cause that?