[mariux0510]

Hello,

Maybe somebody had similar problem when after crash car Ford Fiesta 1.6 2009 EDC16 not starting, starter rotates, fuel pressure it's normal, immo working, no faults, fuel cut off switch not found,  but when discconected injectors and try starting there are still no faults?   Maybe are there any secrets to starting after crash? 

Thanks!

[virtualman93]

for the inertial switch you can check under the glovebox, maybe you have to remove glovebox,usually inertial switch is yellow.
Or you can try this method:
1.close all doors
2.Switch in position 2 the key for 30 sec.
3.switch on and off few times the key.
4.try to run engine.

[mariux0510]

This method not work, maybe is another method? 

[mariux0510]

Maybe somebody have solution? 

[autoport]

give it a bit of start spray directly on turbo (disconnect the tubing) if it starts you maybe have a fuel problem.

[mariux0510]

I write new ECU eeprom file and engine it's work, but after about 10 seconds it's off. Maybe original file with crash function, maybe possible reset this eeprom? With original file engine absolutely not work  or maybe need synchronization?