[anjomag]

Hello,

who can do a good remap for my car renault kangoo 1,5 Dci ?

here is ori file

[naphosim]

Map is incomplete read must have 256kb

[anjomag]

Map is incomplete read must have 256kb

i read this file with galletto and i did limits off with volta software and write file again in ecu with galletto and car did not have limits now
are you certainty that file is incomplete??

[pinotec]

Map is incomplete read must have 256kb

delphi DCM1.2 file is 128kb read partial and 480kb full read
delphi DDCR file is 40kb read partial and 256kb full read

[anjomag]

Map is incomplete read must have 256kb

delphi DCM1.2 file is 128kb read partial and 480kb full read
delphi DDCR file is 40kb read partial and 256kb full read

how can you do full read?
i just can read selecting Delphy E4*Can
i attached images about read and file

regards

[pinotec]

how can you do full read?

with fgtech ,bootmode
see DOCUMENTS\BOOT_MODE_ST10_C167\Renault_clio_ST10F280.jpg

i just can read selecting Delphy E4*Can

file is ok, fgtech with obd read partial file (128kb)
for work tuning this file is ok

[anjomag]

how can you do full read?

with fgtech ,bootmode
see DOCUMENTS\BOOT_MODE_ST10_C167\Renault_clio_ST10F280.jpg

i just can read selecting Delphy E4*Can

file is ok, fgtech with obd read partial file (128kb)
for work tuning this file is ok

ok now i see, thank you.
and for write is necessary do in boot mode? or can be by obd?

[pinotec]

If use file 128kb write obd