[scottwhd]

Hi guys...Im a new user here and fairly new to Immo programming...Can someone assist with my issue. I have a 1998 CRV Honda with all keys lost. I took a read off the Bakom HLI 502 immo and got key mumbers out of it using Immo service tool 1.2. I programmed the chip (megamos 13 T5 with all the 4 key numbers on 4 seperate occasions (pic enclosed) and car would not put security lamp out or start. I then read the bin file with my Zedbull mini and programmed the key again.....Completely different number to the other 4. Security lamp goes out but still no crank or start. I have also enclosed 16 bit and 8 bit version of the bin file. Pretty sure Im dealing with a 16 bit 93c46. If I remove immo board oiut of engine ecu and bypass start wire at immo box car does run fine. Any ideas please on what is wrong. Rar file attached with files cheers and thanks in advance.

[raffy haddad]

Try program these data to t5 transponder
FF813478C4BDC770
This should be the data to program chip report back please
Keep orig data file as 16 bit

[scottwhd]

Try program these data to t5 transponder
FF813478C4BDC770
This should be the data to program chip report back please
Keep orig data file as 16 bit

I entered those numbers in to the key chip not the bin file...correct? It has given me cranking but no start and the green security lamp is flashing.

[raffy haddad]

Those data are different that your data in picture
Just check
Also if still light blink try with diagnostic device to learn ecm

[strikeforce]

or check you soldering work.

[scottwhd]

Those data are different that your data in picture
Just check
Also if still light blink try with diagnostic device to learn ecm

What did you mean by this comment??
"Those data are different that your data in picture"

[raffy haddad]

I mean thepicture in your folder showing key data
They are different than data i post
Any way is the car still you working with ?

[scottwhd]

I mean thepicture in your folder showing key data
They are different than data i post
Any way is the car still you working with ?

I still have same problem