[mikelo_74]

Hello all.

The last weekend I installed a reverse camera in a f34 from a partner. With all installed and connected, I add the 3AG in esys, but the TRSVC is not listed in the ecu´s list, so I can´t code it.

Some suggestions?

I chekked the can wires and are ok, voltage is present. 

Thanks.

[PsevDo]

Hello all.

The last weekend I installed a reverse camera in a f34 from a partner. With all installed and connected, I add the 3AG in esys, but the TRSVC is not listed in the ecu´s list, so I can´t code it.

Some suggestions?

I chekked the can wires and are ok, voltage is present. 

Thanks.

ICAM camera, or with trsvc module?

[user_530d]

Do you use „read ECU“ and NOT „read VCM“?!

[mikelo_74]

Hi again.



With the 5L coded, i do a TAL calculation, and the car is waiting for a TRSVC, but I can't get it to communicate with the car.
If I remove the 5DL and a the 3AG, after a TAL calculation is waiting for an ICAM. I tested with an ICAM too and nothing... 

The wires are ok, revised twice. 

The car is a BMW F34 poduced the 10/2017.

[Senjorq97]

I think because the car was produced in 2017, the fem does not support trsvc only icam.

[user_530d]

This is F-Series model and don't has icam. 5DL and 3AG need TRSVC here.

This was not right.

[DayvG]

This car is almost 100% an ICAM car. The easiest way to know is to add 3AG to FA and calculate a TAL. If it shows ICAM in RED thats what you need. I highly suspect it will show ICAM not TRSVC.

[user_530d]

You can generate SVT with VO 1017 (ilevel 0717), F34 car. SVT is with TRSVC

[The CaT]

This is F-Series model and don't has icam. 5DL and 3AG need TRSVC here.

It has, from 17-07, only with one camera though. 
As far as I remember, both ICAM or TRSVC supposed to be connected to low-speed CAN1. It's worth to check if the vehicle's FEM has it.

[user_530d]

When i take a look at parts catalogue he give me TRSVC partnumber for both 3AG and 5DL???