[m1ke]

Hello, it doesn't work.
if the drawing on the screen.
He disconnected sensors and circulated more than 20KM and there is still.
Can it be removed from the engine map?
Thank you all.

What message is on the screen?

---

And was message on the screen before dpf solution applied?

If it was you might have to carry out service regen with vcds or fit new dpf routine.

[DavidForgac]

1. Upload the original software from DPF
2. Write down the new DPF filter
3. Record the DPF OFF file with the temperature and differential pressure sensors disconnected.

If the light will reappear, your DPF off solution is bad.
I had a similar problem on EDC17CP14 Skoda octavia 2 RS 125kW

[jeam]

The problem that I don't have the original file.
The vehicle already came with the filter empty and DPF already deactivated.
I tried to upload an original file from another vehicle but it gives me an error.
Thank you.

[m1ke]

The problem that I don't have the original file.
The vehicle already came with the filter empty and DPF already deactivated.
I tried to upload an original file from another vehicle but it gives me an error.
Thank you.

You still didn’t answer questions, was light on before customer had file originally modified? Have they tried fit new dpf or service regen diagnostic?

[jeam]

Hello, yes it was on, that's why I take it to empty the filter and modify the file.
But the warning didn't go away.
Tomorrow I will try to adjust the forced regeneration and reset the DPF.
Thank you very much.

[jeam]

Hello, I have disconnected everything I have tried to reset everything.

There is no way, I don't know what else to do.
There is no engine error.

[al70]

you will need an original flash file and do proper dpf off

---

post the numbers of the ecu or a photo of the label

[Leaking]

Test this pass pm. You need to drive ~20km with my file. Report back after.

WinOLS (13612.rar
File Type:
Downloaded:	1 times
Size:	53.87 KB

[jeam]

Thank you very much, I'll try tomorrow and comment.
Thank you.

[jeam]

Thank you very much, I have followed the guidelines, but it does not work,

Follow the problem.
I connect the sensors and try again?
Thank you very much.