[anjozeron]

working on jetta 2013D

[opp0927]

May I ask if you have encountered ODIS7.2 version can not save the diagnostic file in the W7 operating system

[pendragon1]

1390 tested with a Audi A3
all works fine
many thanks to Tadk

[Jacce75]

1390 tested on
- VW PASSAT Variant (365) 1.4 TSI EcoFuel CDGA 2013, all ok. Made online SVM software update and SVM coding among some GFF.

[fantomel]

May I ask if you have encountered ODIS7.2 version can not save the diagnostic file in the W7 operating system

in the specific thread and also in all tadk posts u will see that open launcher solves that issue.

[aportnov]

After installing postsetup at startup, ODS6501E error (didb_FS... not found)

[Tadk]

After installing postsetup at startup, ODS6501E error (didb_FS... not found)

you need to reinstall the program, after removing the remnants of an unsuccessful installation

[aportnov]

Once again, I completely cleaned everything and reinstalled it, it starts. I'll check in the car one of these days.

[aportnov]

1390 tested on.
I checked on the Audi a6 c7 (2016), the car is working, it sees, but it does not see the ignition key.

[Tadk]

Update_ODIS-Service_7.2.1-EU_Postsetup_70201.101.1460_test ( 16,42 Gb )


Update 70201.101.1390-to-70201.101.1460 ( 865 Mb )

TEST! No guarantee!

For those who have experience and ability please check it by working on real cars and please write if you find errors or not.
This is not an official postsetup, so you use it on your own risk.
Corrected to work with Softing 505x interfaces under Service 7.2.1 and updates are from version 9.1.0, Postsetup 90100.207.340.

Don't spam thread and PM (Private Message) me for password.


Patch update for 7.2.1 (no problems with log saving):
https://cartechnology.co.uk/showthread.php?tid=58980


Before you start installing Odis from 5054 on Windows 10, you need to do the following:

1) install PDF viewer

2) enable: control panel - uninstall or change a program - enable or disable Windows features -.Net Framework 3.5

3) install font Arialuni

4) installed Visual C++

5) using file bat., install version 6.2.0 with the choice of 5054, then specify the postsetup from version 7.2.1
Attention: if you have installed or are going to install engineering,
then you need to comment out the program folder during the installation
of programs or updates: Program Files (x86)\
##Offboard_Diagnostic_Information_System_Engineering
If after updating or installing a folder with the same name as the commented one appears,
then you need to delete it.
For example: if you install or update the service, then comment out the engineering,
if you install or update the engineering, then comment out the service.

6) The installation file of the program and the bat. file must be in the same folder.

For example Service, desktop location:
Run command prompt as administrator:
cd \Users\username\Desktop
run.bat OffboardDiagSetup-Service_VWMCD_6_2_0-0103_8.exe

For example Engineering, desktop location:
Run command prompt as administrator:
cd \Users\username\Desktop
run.bat OffboardDiagSetup-Engineering_12_1_1-0102_2.exe