[Jay_86]

Hi, I have a question for you guys, what battery charger/power supply do you use for coding and flashing?
I currently have a Ctek pro25s 25A with suplly mode....

Have any of you done a vehicle update with this unit or would it be better to get a more powerful one?

I think just to code it will probably do, but what about flashing/updating? 
I drive a F11 LCI 

Best regards

[moreply]

I do Updates with the Pro S all the time. No problem at all.

[noobontour]

https://cartechnology.co.uk/showthread.p...owersupply

There you can find a lot of information about that topic.

[Jay_86]

https://cartechnology.co.uk/showthread.p...owersupply

There you can find a lot of information about that topic.

Thank you, the thread I have somehow overlooked in the search 

[Eyestorm]

I use this one but its expensive. The Bosch Bat-690.
90 Amps.

[abrek]

Flashed nbt evo and I used ctek 25s pro as power supply. Everything fine

[Almaretto]

No charger needed for coding. I use Schumacher 700A for flashing.

[st1]

Which one for lithium battery M cars?

[aleksandrw]

i use doctor charge 130 from telwin , it was 500euro new when i bought it last year .i have also dr charge 50 ,but with 50 sometimes when battery is not so good and you have to keep ignition on for long time it doesn't work well.

[slackers]

I'm looking at a Meanwell RSP-1000-15 for flashing my F11 LCI - It's an industrial PSU so should be good enough and from a reputable manufacturer rather than a cheap Chinese import option from Amazon/Aliexpress.

I'd love a proper unit but with most being around 500 EURO+, it's too expensive for "single use".

25 AMP is well below the BMW recommended current though.