[Liteace]

I need help please, I have installed ISTA 4.39.20, that I want to use with genuine GM mdi2, I know the mdi2 works OK in pass thru mode as I use it with JLR SDD + others.

in ISTA vehicle interface settings I have "Pass-Thru tool (SAE J2534)" selected.


   



I tried today to use on 2015 F20 116D, When I click on "ID without vehicle test" or "complete ID" the GM mdi2 wakes up and the lights flash like it does when its making

communication with the vehicle but then I get this message



   



What other setting do I need to edit or change to make?

[user0086]

Just to double-check since you didn't explicitly state it, did you actually switch on the ignition (in the sense that the check-engine light is on)

[Liteace]

Just to double-check since you didn't explicitly state it, did you actually switch on the ignition (in the sense that the check-engine light is on)

Yes ignition switched on, also tried with the engine running and the same problem?

[user0086]

Did you install BMW PassthruD?

[2013m5]

If you're needed the BMW PassThruD 3.0.11.86. Here is the link, thank you and the rep. for the poster.

https://cartechnology.co.uk/showthread.p...pid=545857

[Liteace]

Did you install BMW PassthruD?

Yes BMW PassthruD is installed, when I click/open it the GM mdi2 j2534 is found and listed ?