[Soll75]

EDC15C4-8.3 0281010144.rar
File Type:
Downloaded:	21 times
Size:	126.14 KB

EDC15C4-8.3 0281010144.rar
File Type:
Downloaded:	21 times
Size:	126.14 KB

 Hello, please help with the solution to disable the immo on the ECU 0281010114 soft 1037351761 Eeprom and flash attached (29f400 and 95P08). I have a swap project where the engine and ECU will be installed on another car and installing a combination of EWS and DME is not desirable. Thanks

[foxportal]

test and report

try but need full.

[Soll75]

Thank you very much, I will check and report back.

[Soll75]

Hello, I checked the file sent foxportal wrote kess block was written completely but at the end got an error (there was an error during recording). When you connect the diagnostic unit is detected, but read the errors or see the current parameters does not allow.

[raffy haddad]

For this ecu you need full read and write , kess read partial file not full
try to rewrite orig read and test if all ok
read in boot mode
regards

[Soll75]

When writing the original file everything is fine, the unit is diagnosed and shows the current parameters. I can read the flash with the programmer, but what to do with the checksum. If you need, I will post the flash read by the programmer.

[raffy haddad]

Is foxportal file started the ar ? And he mentioned that need full read
chk can be made with chks tool
if foxportal file not start the car read flash in programmer and post
rehards

[Soll75]

Here is what I read with the help of the programmer

[mkii]

try this .................

[Soll75]

Recorded KESS was successful, the unit goes to the diagnosis, the parameters displayed no error EWS, diagnosed with Bosh KTS 540. Check the startup is not possible yet as I will check in the thread or personal messages. Thank you all so much for your help.