[ROD-BENDERS]

Ktag will be ok.. try fc200 if it uses egpt

[ltujustas]

Ktag will be ok.. try fc200 if it uses egpt

Here BCM2. Now will try to read non crypted ecu

---

Ktag will be ok.. try fc200 if it uses egpt

It use egpt. But read only ext-int flashes in one file. I can only read separately in boot mode

[ROD-BENDERS]

Ktag will be ok.. try fc200 if it uses egpt

Here BCM2. Now will try to read non crypted ecu

---

Ktag will be ok.. try fc200 if it uses egpt

It use egpt. But read only ext-int flashes in one file. I can only read separately in boot mode

Read them with ktag.. save files seperately

Br

[ltujustas]

here's both ecu

[ROD-BENDERS]

Two hours i will take a look

Br

[ROD-BENDERS]

Ktag will be ok.. try fc200 if it uses egpt

Here BCM2. Now will try to read non crypted ecu

---

Ktag will be ok.. try fc200 if it uses egpt

It use egpt. But read only ext-int flashes in one file. I can only read separately in boot mode

I have had a look.. the bcm2 is a mess with most modules CS missing

Need full read of ELV and TCU to find CS and MAC values

I have added ECU CS and MAC but that is all we have

Powerclass is the same among ecu and bcm2 (BC)

Do you have a 512 byte key file read by vvdi ? if so post it please we may decrypt the missing values

BR

[ltujustas]

Sorry for a late response
here dump from key

[ROD-BENDERS]

Thanks i will look tomorrow morning

Br

[ROD-BENDERS]

data decrypt success
write slave ecu eprom and try car

if still not starting write bcm2 eprom-fixed

and you have 32 byte sync key data

br

[ltujustas]

Everything works fine, car starts without safe. But in slave ecu error ecu swapped. Maybe turn off that dtc in flash ?