[bm92]

Hi everyone, this is the first time i have this problem.
I used VVDI2 to program new key on E46 and before programming key i had a message "some keys have been disabled do you want to make changes", i clicked YES and saved new eeprom.
After programming a new key, original key and new  key can't start the car !
Even if i try to do EWS DME reset start value ISTA says EWS is not new or problem with the key.
I think original key is corrupted now.
Can someone please reset/renew EWS so i can program new key again ?

Thanks in advance

[Hoborg]

Restore EWS from copy. You did it ?

[bm92]

Yes, always the same.
I'am sure that both keys (original and new one) are messed up now ...
I'am going to buy new 7935 because it was my last one.
I will program new pcf from new eeprom...

[Vojno]

If you read the EWS in car, I mean normal diagnose (INPA or ISTA) can you see the key status?
What is wrong wit the keys?
1, password, 2 rolling code or 3 disabled the key?

[izm]

try this one with old key and sync code also

eep new key9-unused.rar
File Type:
Downloaded:	3 times
Size:	386 bytes

[johann74270]

Hi
try this file with new key code

[bm92]

Hi everyone and thanks for the help.

I bought new pcf 7935, load modified eeprom by VVDI2 in my first post, program new key again (key 7) and car started immediately without problem !

I don't know what happened but i can confirm that EWS and DME were ok.
Original key and first new key that i programmed are not working.