[sulibrk]

Hello, I am replacing dash in Skoda Fabia MK2 pre-fl.

I am unable to connect with any device i have.
Tryed :
-genuine VVDI2
-genuine KeyToolMaxPro
- SVCI2020
- VagTAcho
- Vag K+CAN commander

no single success

So i read eeproms with VVDI Prog and would like to ask you - can you help me get PIN and transfer KM from old cluster to new one please?
I do not understand why this one is so special it could not be done by OBD with my available devices.
Also, what software can be used to read and decrypt this special eeprom file?

Cluster i need to put in car and change Km in is : 5J0920841C VD1
Old (actual cluster in car, which i need to transfer information from) 5J0920810C VD1

Original value in old dash i need transfer to new dash : 201914km

[evg_eni]

Pin orig 05094
Pin new 01054

Here dump new Maxidot cluster with orig mileage. If adapttion with vcds is not sucessfull i can try immo transfer. share results.

[sulibrk]

Hello good sir. Thanks! Odometer is ok. Both pin looks ok as well but when doing last part of adaptation on channel 50 it says wait and then malfunction.

[evg_eni]

You are trying on 25 immobiliser right?

[sulibrk]

Yes, sure.

25 - immo
Login with actual pin
Adaptation
00 reset
50 writing old pin
Then i see green wait, then malfunction after a while

[evg_eni]

00 reset, you can skip that.
Ok i will try tomorrow to clone. Do you have ecu dump?

[sulibrk]

No but will read the ecu in the morning.
Shall i read it on bench or OBD is enough?

[evg_eni]

Hi, try this dump and check if the car will start. pass on p.m

[sulibrk]

Going to try now. Thank you.
BTW - do you still need the ECU dump?

[evg_eni]

BTW - do you still need the ECU dump?

if you can read by obd, yes post it.