[fantomel]

FGTECH GALLETTO V54 FIX EPT HEX DUMP & PROGRAM FOR 0475 AND 0386

What you can find here:

1.For tool number 0386: ept file,fix file,hex dump and 2 versions of programs V54 used for it, the one from china and the AES November software.

2.For tool number 0475: ept file,fix file, hex dumps made from my tool and program V54 for it that does not need time back.

3.For both tools you have here how to connect to it, how to read firmware movie, how to write dump that you wish.

Reading and writing the mcu for this tool can be done with old Philips LPC 2000 software and USB-TTL adapter, preferd the one that uses PL2303 chipset. You need also a jumper in position to do that.
If you want to check CRP level of your NXP LPC2119 mcu you can do that with FlashMagic and USB-TTL adapter.


Password: fantomelfree4galletto
Enjoy.

[ToNy68]

Hello,

Can I use it with v53 ?

thank you

[blacklisted]

Only v54 with the above serials

[rs@chip]

What is the diferents betwen china and AES for 0386 number ? are this better softs and dumps than ori-ones which came with v54 china?

[fantomel]

Aes and china uses same key for v54 witch in fact is older version of soft and bootlloader then 0475.

[rs@chip]

Are there any eprovment if reflash..my v54 cant read a lot of ecu on can-bus and bdm

[fantomel]

The question is how is your reworked board? Is it or is it not? is it proper or not ....... it does not matter only fw+soft you know ....

[rs@chip]

I didnt rework anything yet..I have problems with can-line and bdm mpc55xx 56xx..k-line works..can you tel me which part need to be replaced to make this work?thanks..

[toms4]

For BDM change 74HC14, and resolder noncorrectly soldered pins on pcb (relays)
CAN issue can be 82C250

[rs@chip]

Thank you for that info ..noncorectly soldered pins..you meen relays?