[NickMayer]

hi , can anyone share calculator or just help to edit eeprom right way , thx 
read out vvdi prog , milige need to change to 61000miles (not km)
thx

[Clusters]

And the original value???

[NickMayer]

thx everyone , but i have little problem .
i dont have special adapter for vvdi prog so i can not edit it , only what i can do is reset to zero and adjust milage in cas4, that is what i did , but when i change first 2 lines with fffffffff and out in the car it gave me 999999 miles , cas4 looks ok no errors , now i edit cluster file again but put 000000 instead of fffffff but not sure if need checksum corrected . i post files before and after , cam some one look at it .
1952 [7A0h] this location is chechsum? i just looking files what you send me and one of the files have 52 insted of FF what was originnaly in the file .
and some of your files smaller then my original.
original file go sone info from 2048 [800h] to 2111 [83Fh].
and some of your edited files ending at 2048 [800h] and little part is missing .
sould i remove this part from my verzinise file ?
i attach cluster to zero version 1 and 2 edited my me , and cas4 4 to 63154miles
can anyone look and see if i corrected right , thx

BMW CLUSTER 35160WT 2017 X3.zip
File Type:
Downloaded:	3 times
Size:	1.28 KB

cluster version 2 need to check if corrected righ.zip
File Type:
Downloaded:	2 times
Size:	1.27 KB

cas 4 edited to 63154 .zip
File Type:
Downloaded:	3 times
Size:	5.34 KB

[huzefa]

thx everyone , but i have little problem .
i dont have special adapter for vvdi prog so i can not edit it , only what i can do is reset to zero and adjust milage in cas4, that is what i did , but when i change first 2 lines with fffffffff and out in the car it gave me 999999 miles , cas4 looks ok no errors , now i edit cluster file again but put 000000 instead of fffffff but not sure if need checksum corrected . i post files before and after , cam some one look at it .
1952 [7A0h] this location is chechsum? i just looking files what you send me and one of the files have 52 insted of FF what was originnaly in the file .
and some of your files smaller then my original.
original file go sone info from 2048 [800h] to 2111 [83Fh].
and some of your edited files ending at 2048 [800h] and little part is missing .
sould i remove this part from my verzinise file ?
i attach cluster to zero version 1 and 2 edited my me , and cas4 4 to 63154miles
can anyone look and see if i corrected right , thx

only first 2 line 0000 
and edit in cas no need to do anything

[NickMayer]

problem is with vvdi prog without adapter i can only put fffff in first 2 lines

[Pentheus]

Protection of the First 32 Bytes
The first 32-byte page is organized as 16 words
(two bytes each). The initial content of each word
on this page is 0000h. When writing to byte-pair, a
logic comparator verifies that the new two-byte
value is larger than the value currently stored. If
the new value is smaller than the current one, no
operation is performed.

[fitacuevas]

for 35160wt vvdi prog cannot change the first 2 lines. you must use vvdi 35160DW chip.
You read the original, copy it to the vvdi chip and set the first 2 lines to 00.