[Hoborg]

Always the ip change when you make fw update also on original icom....

This is not true , I have one original ICOM and one clone , first has static IP 192.168.1.45 and second 192.168.1.46 and after update firmware with newest ISTA/D all IP configuration is preserved, and all works of course.

[tste1982]

Hello a question.

I have installed the package MS Installer BMW_ISPI_ICOM-FW_03-14-03.msi firmware update, and I get the following picture. It does not appear free connection Manager

Is there any way for the firmware update automatically, or should I do it manually.

i had the same problem, and i needed to update via web interface.
is this an issue of ista-d or my icom?

regards

[SweetBMW]

Go to connection manager. (Not the one you are in) and there is a button called configure interface.

[petkowo]

Go to connection manager. (Not the one you are in) and there is a button called configure interface.

where?

[duckman]

Http://169.254.92.38:60080/

user :root
pass:NZY1150263

[SweetBMW]

Go to connection manager. (Not the one you are in) and there is a button called configure interface.

where?

On the top bar. There are many buttons. One of them is the connection manager where you can update the firmware

[Sour]

Go to connection manager. (Not the one you are in) and there is a button called configure interface.

where?

On the top bar. There are many buttons. One of them is the connection manager where you can update the firmware

can you put an picture. I'm lost.

[SweetBMW]

Middle button

   

[jaramillo]

Here is another flashing procedure:


ICOM, ICOM A1 and Common ICOM A2 Firmware Update Steps and Note:

9 Steps:
1. Use Network cable to connect ICOM (ICOM A1 or Common version ICOM A2) with a computer, charge ICOM (ICOM A1 or Common version ICOM A2) with 12V power adapter or connect ICOM with the BMW vehicle.
2. Open IE Internet Exploer, browse http://169.254.92.38:60080/, log in with username/password: root/NZY11502.
3. Click "Update Firmware", you will see ICOM firmware version information.
4. Choose file "ICOM-BootImage-xx-xx-xx.bin", set image type to SYSTEM, click "Send the file".
5. When it pops up "Write the image file to the flash?", click "Yes", then ICOM indicator light will turn red.
6. When it pops up "The SYSTEM IMAGE update was successfull", click "Update Firmware".
7. Choose "ICOM-ApplicationImage-xx-xx-xx.bin", set image type to APPLICATION, click "Send the file", it will take several minutes since the file is a little bit large.
8. When it pops up "Write the image file to the flash?", click "Yes", then the ICOM indicator light will turn red for the second times.
9. When it finish upgrading, click "reboot" to reboot the computer.

Important Note:
1. Setting up your computer to obtain an IP address automatically
2. Firstly choose the smaller file "ICOM-BootImage-xx-xx-xx.bin" , then set image type to SYSTEM;
Secondly choose the bigger file "ICOM-ApplicationImage-xx-xx-xx.bin", then set image type to APPLICATION.

[SweetBMW]

Yes but the other way is easier