[CATAHA]

Hello, as i know the Ford software is able to work with J2534 Passthru device no problem, such as actia, Alliance, etc.
But if anyone can help with the settings? i tried to setting in J2534 Config software, as well as edit the register (rename the VCMII by replacing with j2534 device register folder) but no success.
Can anyone teach the setting details?
Thanks so much!

I haven't used it for at-least 3-4 months but from what i remember
Install Passthru Drivers, FMP/IDS install program, start program, check on configuration page, choose Passthru device
You are done

Also i posted Videos that have been made by Snap-On
H.E.R.E

Hi CATAHA,
Thanks for your guide, it seems that i need to install a softwar called FMP.exe then the J2534 device is able to work for programming through the video you provided, i want to know if the FMP is also necessary when i use diagnostic function? where i can get one without subscribe @Motocraft??
Thanks and best Wishes!

It's best to Use Mazda IDS along with offline DATA(flash) since Mazda Does not require activation(or easily bypassed)

This Dude is on this forum

---

On another forum before they wanted to RENAME my nick and remove my passwords... i made a post already at once

"3.6. Selecting a Different SAE J2534 Pass-thru Device
During the initial application start up, an SAE J2534 pass-thru device was selected (See Section 3.2).
If a different SAE J2534 pass-thru device is going to be used, it can be selected using the following
steps:
• Close the Ford Module Programming application
• Install the software that was received with the new pass-thru device on the PC
• Click on the Windows "Start" button
• Select "Programs"
• Select "Ford Motor Company"
• Select "FMP"
• Select "Change J2534 Device"
• Select the manufacturer of the new device
• Select the specific device
• Select "Save"
• Select "Exit"
• Connect the new pass-thru device to the PC and power it up
• Start Ford Module Programming using the icon on the desktop
"

H.E.R.E