[Dash_Burner]

It is tested on k-tag 2.13 6.070 fw and reset tokens

1. Format sd card and put it back to the unit as is (empty)
2. Copy and replace update folder into installation folder of k-suite
3. run k-suite and wait.


Dont forget to turn off internet connection

Pass by pm after thanks and rep

PM (Private Message) for password, do NOT post in thread for it, it will be removed.

Thanks, Admin.

[Dash_Burner]

It is tested on k-tag 2.13 6.070 fw and reset tokens

1. Format sd card and put it back to the unit as is (empty)
2. Copy and replace update folder into installation folder of k-suite
3. run k-suite and wait.


Dont forget to turn off internet connection

Pass by pm after thanks and rep

I also have to say that i used this sw before tokens finished (5 tokens remaining) For users that used it with success please report.

[Dash_Burner]

No reviews ?????

[Clusters]

You got 27 thanks and +23 rep, are you that desperate for recognition?

Be thankful you didn't get any negative reviews.

[lokher]

PERFECT

thanks

[betrescudan]

First of all
j-link can"t be used for 6.070 with CRP3 level nxp protection activated...so,no sense to talk about reflashing nxp for this firmware
then...
for reset,need to use ksuite 2.08 sw
then...
this method will work untill sdcard will crash
there are a lot of cfg files for this reset...try to use search buton
i mean...25 files cfg for 750 tokens
insert only one cfg file into update folder from 2.08 and start ksuite...job done
reset tool with same cfg file will fux your tool

[Pzolee]

It is tested on k-tag 2.13 6.070 fw and reset tokens

1. Format sd card and put it back to the unit as is (empty)
2. Copy and replace update folder into installation folder of k-suite
3. run k-suite and wait.


Dont forget to turn off internet connection

Pass by pm after thanks and rep

PM (Private Message) for password, do NOT post in thread for it, it will be removed.

Thanks, Admin.

2.13 ktag not working.
Please check

2.11 working.

2.13 what solution?

thanks

[domelec]

Ktag must use ksuite 2.11
kess must use ksuite 2.08
this as been said over and over again any higher is a waste of time without newer fw

[Dash_Burner]

Ktag 2.13 fw 6.070 is working 100%. Thats mine which i tested i will send picture tomorrow
Sometimes problem is in sd card. Change it and all will be ok.
BRUCE empty mail box. you can not receive messages

[domelec]

And if you read correctly fw 6.070 uses ksuite 2.11 any higher is for newer fw which was never out free
now newest fw is 7.26 using ksuite 2.23