[ljscodex]

Hi, im trying to change mileage to captiva, but i have problem with dashboard.

Car start ok, but no lights, rpm...

i have upa, orange, carprog , but with none of this can get a good read dump.

i attach the last read dump.

anybody can tell me if i can use another binary and modify VIN number without start problem (immo)?

[rch11]

Hi, im trying to change mileage to captiva, but i have problem with dashboard.

Car start ok, but no lights, rpm...

i have upa, orange, carprog , but with none of this can get a good read dump.

i attach the last read dump.

anybody can tell me if i can use another binary and modify VIN number without start problem (immo)?

Yes.
Yours dump is bad

[ljscodex]

Yes, im triying to write with orange (attached file) but, i get a lot of errors .

in picture you can see pinout.

[rch11]

Yes, im triying to write with orange (attached file) but, i get a lot of errors .

in picture you can see pinout.

Try this

[brunofraga]

Yes, im triying to write with orange (attached file) but, i get a lot of errors .

in picture you can see pinout.

Please try to read with upa first make sure you connection are right, power in one side- ground on the opposite, in between the reset and underneath ground will be the bkground. I hope this helps good luck.

[ljscodex]

I cant get good read, i cant write

[destroyer]

Put here Photos all board
maby your points is problem

[ljscodex]

Here you have full dashboard

[rch11]

I cant get good read, i cant write

Green with yellow are bad

[ljscodex]

I cant get good read, i cant write

Green with yellow are bad

yes, but i changed a lot of time.

i'll test removing red ( vcc) from programmer and send 12v and ground to dashboard connection.

UPA Cant read....