Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
[TUTO] Activate Laptimer and Needle Sweep in 8P and 8J Dashboard
20-01-2018, 16:38 PM,
Post: #21
|
|||
|
|||
RE: Activate Laptimer and Needle Sweep in 8P and 8J Dashboard
Yes mate, this is what I did. 61 is fine, but 60 gives me safe error, glow plug flashes, and mileage goes up.
|
|||
20-01-2018, 17:22 PM,
Post: #22
|
|||
|
|||
RE: Activate Laptimer and Needle Sweep in 8P and 8J Dashboard
Tested on my bench and mods work with your eeprom.
I was able to activate needle and laptimer in your eeprom I am not able to look the mileage trouble because i don't have your micronas dump , but from my experience the trouble what you describe can come from a bad writing of dump on the eeprom. Don't forget to add me and if I helped you
|
|||
20-01-2018, 17:28 PM,
Post: #23
|
|||
|
|||
RE: Activate Laptimer and Needle Sweep in 8P and 8J Dashboard
I use ori smok, and write eeprom via obd. Could, you, please post modded dump?
|
|||
20-01-2018, 17:41 PM,
Post: #24
|
|||
|
|||
RE: Activate Laptimer and Needle Sweep in 8P and 8J Dashboard
I do it directly on the dash by xprog or any i2c programer with clip
|