Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Siemens SID801A, read, write ECU
10-02-2018, 06:57 AM,
Post: #11
|
|||
|
|||
RE: Siemens SID801A, read, write ECU
Hello Greek.damjan thank you for your answer.
Mine ktag is a 7.020 and know supports sid801A. Well I will do this. And the boot pin wire you removed it from the ground before start dump? Somebody tell me that he got a corrupt dump file if wire not removed before reading. He checked the dump file with an ori with the help of a hexdecimal editor. What do you think about this? What hp was your engine ? Maybe I could compare with ori file below but mine is a 406 2.0 hdi 110 Thank you |
|||
10-02-2018, 07:21 AM,
(This post was last modified: 10-02-2018, 07:29 AM by grmsek.damjan.)
Post: #12
|
|||
|
|||
RE: Siemens SID801A, read, write ECU
Your Ktag 7.020 support sid 801A?
YES,removed..when the warning message appear put ignition off(switch), put boot pin on mass( I put it on black gnd wire),turn ignt. on(switch),after half a second to one second pud down boot pin from mass)..press OK..finally started reading..the same for writing Mine was 90hp Texa idc4, Renault canclip V156, PSA XS evolution 8.22, autocom, multiecuscan, OP-COM 1.64, VCDS, TOYOTA techstream, MPPS V16 eu, Digiprog3, Bmw rheingold, carprog
|
|||
10-02-2018, 12:17 PM,
Post: #13
|
|||
|
|||
RE: Siemens SID801A, read, write ECU
I don't want to make any mistakes but i think that it supported in ktag to read write via bootmod and verify checksum please watch pictures and say what you think
sorry it is in french |