[manueldord]

Hello fellow is it possible to do immo off in this car I have starting problems

or if someone has a complete bdm with key

can someone help me with this psg16 thanks and regards

[dil6222]

Hello fellow is it possible to do immo off in this car I have starting problems

or if someone has a complete bdm with key

can someone help me with this psg16 thanks and regards

What starting problems are you having cold start ,hot start

If you can't start after leaving over night and takes ages to crank before starting it is either injector seals or leak of pipes from injectors they cause the fuel to run back to tank or its glow plugs or glowplug relay.

Also the pump usually cause most problems the fuel metering valve fails or the ecu fries try spraying easy start and see if fires.

Let me know tho as have done a lot of work on these engines

[manueldord]

I put a new scrapping pump but I can not synchronize with opcom and it gives me immobility

that's why I'm looking for a full bdm eeprom of the immo and the key to be able to record everything and be able to start

or do immo off

thanks and regards

I do not have tech2

[dil6222]

I put a new scrapping pump but I can not synchronize with opcom and it gives me immobility

that's why I'm looking for a full bdm eeprom of the immo and the key to be able to record everything and be able to start

or do immo off

thanks and regards

I do not have tech2

Read pump pin with carprog then reset with opcom and recode into system there should be program option for pump will let you enter matching security code from other parts bdm ecu etc program it and should work try and let me know how you get on

Where bouts you from ?

[manueldord]

Everything what it has said to me what e tried and follows light of immo in the picture

---

when I do the steps with opcom gives me everything ok minus one that gives me failed

[pajo4]

Everything what it has said to me what e tried and follows light of immo in the picture

---

when I do the steps with opcom gives me everything ok minus one that gives me failed

reset to pin to psg 16 carprog programing to opcom to pin win

[dil6222]

Everything what it has said to me what e tried and follows light of immo in the picture

---

when I do the steps with opcom gives me everything ok minus one that gives me failed

Try firmware 1.59 for opcom reset the whole system under immo there is option for new immo and ecu installed there may be option for pump added to that as well can't remember. post some screenshots of the failure
Here

[manueldord]

Hello colleagues forgive for the delay here enclosed the failure that gives me of programming

everything I program ok but this failure does not program


have if you can help me thanks and regards

[volavka]

Read pump and see if the code you've entred is registered

[manueldord]

If I have already read a bomb and I get the pin

I have two pins for the car and the one for the new pump, which it refers to

once programmed it keeps coming out the same pin of the pump