Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
F10 6WA KOMBI won't syncronise properly with EVO id5 retrofit
30-01-2018, 18:29 PM,
(This post was last modified: 11-03-2018, 22:39 PM by TurboDriver.)
Post: #1
|
|||
|
|||
F10 6WA KOMBI won't syncronise properly with EVO id5 retrofit
Hi all,
6WA won't sync with evo id5, language always English, units won't change. Previously had NBT didn't have this problem. I've coded EINHEITEN master to hmi but that's only allow changing units on EVO not Kombi, tried change KOMBI_CIC to kombi mid same result. Kombi was updated with V60 so don't think software level is an issue. What else it could be? |
|||
30-01-2018, 20:04 PM,
Post: #2
|
|||
|
|||
RE: F10 6WA KOMBI won't syncronise properly with EVO id5 retrofit
(30-01-2018, 18:29 PM)TurboDriver Wrote: Hi all,Hello did you try to change gateway table ? Отправлено с моего SM-G930F через Tapatalk |
|||
30-01-2018, 20:43 PM,
Post: #3
|
|||
|
|||
RE: F10 6WA KOMBI won't syncronise properly with EVO id5 retrofit
Just VO code the unit and all will be fine, assuming you adjusted the FA if that was required.
There is no need to change gateway table. As long as fibre optic is connected cluster and HU should communicate fine |
|||
30-01-2018, 23:37 PM,
(This post was last modified: 31-01-2018, 01:07 AM by TurboDriver.)
Post: #4
|
|||
|
|||
RE: F10 6WA KOMBI won't syncronise properly with EVO id5 retrofit
It's VO coded. I had NBT fitted before upgrading to id5, it worked fine with NBT
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content