[agad]

Hi guys,

I had to replace my faulty nbt evo touch controller for a used one however I’m getting an error on ISTA saying the “CON” module is not coded to the car and there is no coding data for it. I checked the ZBE3 module on esys and it has no CAFD data. I followed some steps to inject the CAFD files but was stuck at a point where I couldn’t go further.

Could you please help me inject the files? The steps says connect the car then load FA then Activate FA then load SVT then “left” click on the module, actually this is the step I’m stuck at as the left click does nothing when i click on the module!

Many thanks

[maxwell4321]

You need to be using esys 2.71

connect,
read FA
activate
read SVT
click on the Module so it is highlighted
then on right hand side of the screen click button Detect CAF for SWE
Select the latest file in the pop up box.
afterwards right click on the module and select Code

[agad]

You need to be using esys 2.71

connect,
read FA
activate
read SVT
click on the Module so it is highlighted
then on right hand side of the screen click button Detect CAF for SWE
Select the latest file in the pop up box.
afterwards right click on the module and select Code

Hi, actually I can’t use these options! I only have a couple of other choices that aren’t greyed out! Have a look at the attached photo.

Thanks

[lynxbmw]

Use e-sys 3.27.1 because 3.28 has an issue with newer psdzdata.

[agad]

Use e-sys 3.27.1 because 3.28 has an issue with newer psdzdata.

Alright, will do that but just wanted to say that i have the lite psdzdata version which is 2.5GB. Will this make any difference?

Thanks

[lynxbmw]

Use e-sys 3.27.1 because 3.28 has an issue with newer psdzdata.

Alright, will do that but just wanted to say that i have the lite psdzdata version which is 2.5GB. Will this make any difference?

Thanks

Not at all. That's exactly what you need just for coding. Full is for programming too.

[agad]

All done guys! Many thanks