[spanaz1]

Hello,
I was called today to do wiring and install ECU to an old Mercedes 190 in which they have installed a M111 engine from w210 and a five speed manual gearbox. now all the wiring has been done but the ecu is Bosch ME2.0 and am trying to install an emulator to remove immo. now my Question is;
.can I use cr1 from china on this ecu? am thinking of running the HC11 E9 dump on immo universal software then install emulator. is this the collect way?
and after installing emulator they say you have to serial code the ecu before starting, is this step necessary on this car since it doesn't have CAN and no any modules to code the ecu to.

[Chipshop]

Hello, can you posted the pictures of the editing? and also the reference of the ecu

[spanaz1]

You mean the file which I have run in universal immo emulator software? or the original?

[Chipshop]

The assembly of the emulator welds and the reference of your original calculator

[spanaz1]

The assembly of the emulator welds and the reference of your original calculator

her is original and modified for emulator. benz1 is original file. the last one is link to the emulator i have

[Chipshop]

Good evening dear friend, your reading eprom is not good, you must start again, then I will send you a link for the realization of the weld point and the modification of the line cordially

---

link for emulator

[spanaz1]

Thank you friend, so does this mean I have to buy Julie emulator? the one I have can't work? I will read the MCU again

[Chipshop]

Hello, for the emulator it's good, however you have to read eeprom and follow the procedure

[bawareca]

Your dump is perfectly fine. Put the first 8 bytes to 00. Install CR1 emulator. Perform initial startup of the ME. Done.

[spanaz1]

Will do exactly that and I will update.thank you again