[savoy81]

Hello
i need immo off
thank you

[dara]

Hello
i need immo off
thank you

Try it ! this virgin file

Manual key programming procedure

Key Programming:
When reconnected to the car, the ECU will be in auto-programming mode and will accept new keys as
per the procedure below:
1. Briefly insert any key into ignition lock cylinder and remove immediately. The security light should
illuminate and remain on.
2. Insert the first transponder key into ignition lock cylinder for registration DO NOT TURN ON. The
Security light may blink indicating it has accepted the key. After 3-5 seconds remove the first key from
the ignition. Security light should remain on indicating you're still in programming mode.
3. Insert the second transponder key into ignition lock cylinder for registration DO NOT TURN ON. The
Security light may blink indicating it has accepted the key. After 3-5 seconds remove the second key
from ignition. Security light should remain on indicating you're still in programming mode.
4. Insert third transponder key into ignition lock cylinder for registration DO NOT TURN ON. After
security light goes off remove third key from ignition. The security light should extinguish and then
commence to blink regularly.
5. Wait 30 seconds for the programming cycle and programming mode to close.
The first two keys are internally (inside the ECU) designated as MASTER keys and the 3rd key inserted
will be internally designated as the VALET key.