[valentino88]

Hello ca you help me with the pin code of bsi i have one but not shur is it true S7WQ the bsi is johnson control bsi peugeot 3008 eeprom 95128

[volavka]

it is the code location
may need reserve bytes if not work

Good luck

[Mjeppesen24]

I have read the code from your dump. it should be "S7WQ"

[valentino88]

I have read the code from your dump. it should be "S7WQ"

I/ have/ problem/ with/ Peugeot/ 3008 bsi Is dead after xtool km/change I find backup but can not put it bag in bsi take another one now read flash if put the old bakck up and eeprom from the/original bsi is it gonna start the car or not?

[raffy haddad]

Hello
If it is identical just swap eeprom
Good luck

[Mjeppesen24]

My english is not that good,
as I understand your problem

then you have to make a virgin bsi and then config with the diagbox

[valentino88]

There is the probl of the ori bsi there is no answer for be alife nothing show toltal dead now when i take the second hand bsi how i can make it for this car to start thanka alot is it posible to do somethimg with the dumps or nor wich i put if i out the write vin and pin to sea the is is gonna be okey or not thanks advance

Sent from my Lenovo K53a48 using Tapatalk

[Mjeppesen24]

make the second hand bsi virgin. and config with diagbox

ori. bsi .. maybe the flash is bad

[volavka]

Belive me eeprom is fine ,, ,,
you just need move original dump to new bsi ,,,
well virgin is not needed in your case

Good luck

[malguy]

In my case, backup eeprom before you write flash. You need flash of same signature. After you write flash, your bsi will alive again. If it corrupt eeprom after write flash, you just restore eeprom you backup & everything will back to original state.

Regards,