[BabeH]

Recently I have new laptop with Win7-64bit, (that replace the dead D630)
then installed Xentry 3/2018 and DAS patched, Vediamo v05.01.01 activated,
and DTS monaco 8.3.12 activated.

My bad clone C4 need to update firmware to 2.3 CSD2.11
then it is working fine with Xentry and DAS.
I haven't do any online and offline coding,
variant coding is working for me.
I mainly use on MB W204

I'm new to Vediamo and DTS.
In Vediamo it can detect sdconnect, show "...GmbH SDconnect..."
but it cannot read the vehicle.

In DTS, setting interface CBF -> sdconnect,
that cannot open workspace, it said DCIP error something like that.
If unchecked interface CBF, I can open workspace but it won't connect to vehicle.

Is that wrong setting ?
it is not work on 64bit windows ?
and wrong CBF files ?

pls give some hints on Vediamo and DTS.
if it is not free just pm me.

[BabeH]

Finally I've got my new installed Vediamo and DTS Monaco work with C4.
The step-by-step info on internet are not correct for me.

[rukako]

Finally I've got my new installed Vediamo and DTS Monaco work with C4.
The step-by-step info on internet are not correct for me.

Can you share how did you install vediamo because i have the same Problem but using c3 and vadiamo4.02
Thanks

[BabeH]

I'm not using C3 so no experience on it…

Vediamo is easier, in "Update" just try enable everything.
If not work, means it is not supported.
Better try in 32bit windows, some protocol not work on 64bit windows.
(I guess.)

[BabeH]

Now tested on another laptop with Win10.
I don't like using Win10, but it ate less resources than Win7 so it run much smoother.





In additional, DTS monaco and Vediamo are also working fine.

In IC204, Download -> DL_Entwicklungskodierungen
"Tankinhaltsanzeige im Reiserechner (Tank_Level) (Menu_Range_Engeneering)" -> ein

You can read gasoline in liter on cluster display