[ponziopilota]

Hello,
I have a new Corsa-E. I would like to be able to see the settings of the control units via OP_COM. I have a version with Firmware 1.95 and several editions of the VAUX-COM_120309a software with the DB up to 2016.
Has anyone had any experience and can show me how to do it?
Thank you
Gianfranco

[mattydr67]

First of all you are using a clone ( china clone ) with vauxcom 120309a which is a 2012 version. Well you have the 2016 database and this is, as we discused many times, a fake. This means that you can see a list of cars and new years but all depending by the news in that one you cannot do itou do So you haven't the right software version.
I don't know if you have the right interface too
Also you cannot connect to the EPC on CH-CAN either
Anyway Corsa E its not fully developed for all controlers even in last version but its more then in previson vauxcom 160115a for sure
But at least you have DTC read/erase, Mesuring block in most of controlers and Programming for some of controlers as BCM for instance
The right software version for you is the last one OP-COM 170823c
Good luck