[Vojno]

Hi'

after i make correction in dash, looks like work fine, but some ignition on/off the dash do't come up, only after some second and not correctly. It looks like without CAN connection, because i can"t see in three and all other modules are missing the dash.

If I remove it from the battery, it will re-run once, but the next error when switching to next ignition on.

it is a Filter problem? or what?

I hope I was clear?

2012 K1600GT
Dash with 35080 Siemens VDO

[rs@chip]

Hi'

after i make correction in dash, looks like work fine, but some ignition on/off the dash do't come up, only after some second and not correctly. It looks like without CAN connection, because i can"t see in three and all other modules are missing the dash.

If I remove it from the battery, it will re-run once, but the next error when switching to next ignition on.

it is a Filter problem? or what?

I hope I was clear?

2012 K1600GT
Dash with 35080 Siemens VDO

yes sometimes bad can filter..If you conect and set everithing ok than probably need new filter..I had once problem with gecko and fit codecard which worked ok..but I also had isues with codecard filters so you never no..filters are more temperary solutions not best choice