[rommonkeyy]

I bought until now 5 different Carprogs from different Sellers . All Seller said they are repaired and testet 100% .But its Not. I dont Know where can i buy a repaired Carprog and which seller i can trust. I have a last eeprom and its on the Modul in my Car. need to desolder everytime if i want give a new try the eeprom from my Car. And then solder back to Modul because its my dayly Driver.
My last hope was to buy a Universal eeprom Reader and writer . Its finally Finish than.

Thank you very much for your Support .


Gesendet von meinem EVA-L09 mit Tapatalk

[Willail]

Hello,

I have the same problem with my carprog, i have the software 7.28 and impossible to read 95160 and 24C02 eeproms. I test my carprog with the A9 Adapter, no problem. Some people advise to change the 4 iC 74MC125M, but i found that an user had made it but no change, it was always impossible to read this eeproms
Does someone has give you some help?

Thanks

[Willail]

hello,

When i read a bad 95160 Eproom, i have the same information (FFFF everywhere and verify OK). I tried to change a F to zero and write it to the eprom and i have error. I think that i had a problem with my carprog. You have put a file in the site, could you please give me the password? I want to see a reading of good 95160 eprom. Thanks

Willail

[dani3lxxl]

The best, safest ,faster and simplest solution is to remove the eeprom from the PCB and use the carprog eeprom adapter .

in this way, all possible problems are avoided.





Sent from my iPhone using Tapatalk

hi, where can get this adapter??