[yoxardas]

Hello, i'm new here, I have a crappy Meriva 1.3 CDTI Z13DTJ that does DPF regen everyday, i want to remove DPF from ECU but i`m not sure what flasher interface to use, I already have EcuSafe 2.0 and a "SMPS MPPS V13.02 V13 K CAN Flasher Chip OBD2 MPPS V13.02" and a "Galletto 1260 ECU Flasher EOBD Flasher Green PCB FTDI FT232RL Read & Write ECU" but i'm not sure which i should use, any advice ? many thanks !!!

[panasonic1]

better not use these tools for this car, you need kess gallatto 4 or mpps v18

[Errecinque]

Much better to operate in BDM on this control unit with galletto v54 or ktag

and for a correct defap sometimes serves hand solution without sw

[pioan]

Use KESS mate and post file here! I will make dpf off for you!

[yoxardas]

Use KESS mate and post file here! I will make dpf off for you!

Hello, I'm back with the problem, I want to turn off DPF /FAP, it goes on regen everyday even If i changed the particle filter, I have taken down the ECU and READ it with GALLETTO in BDM/JTAG Mode MPC55x/56x, I Have the files here, please be kind and remove that option, I have tried with ecusafe but it doesnt read the file.

[darek_naprawa]

Your file dpf off.

[yoxardas]

Your file dpf off.

Before your file I've used one edited in EcuSAFE and the car worked badly, idle at 1500rpm and fan always on.

With your file it works great, I've connected opcom and at particle filter it says 80% saturation and Forced DPF regen: YES ...

 It is okay? I mean that the car thinks that it's doing "FAKE" regen but actually it works normally without a real regen active. It's normal? i will never see a real regen? 

Thank you so much !!!

[darek_naprawa]

Make reset dpf opcom.

[yoxardas]

I have reset it via opcom (Replace Particulate filter), it still shows "Forced DPF Regen: YES" but it doesn't actually regenerate.. only shows that thing, so I think it's okay. I will test it the next days, usually it was doing regen at 40-50km trip. Many thanks for the flash file, you saved me!