[Pi26]

BMW E70 HOW TO UPDATE CIC GW with Winkfp?

What is the name from module in Winkfp, because the Zb-Nr from Inpa is not accepted.

There a gap between yours questions and the numbers of posts.
Originally, what do you want to do ?
Because Flashing requires a minimum of knowledge, just to not be in the sh*t.
INPA gives ALL you need, just by looking at the correct Address and allready given in #2 post: 63 the CiC, 62 the Gateway, A0 the Hdd.
Take care between reading the Zusb number and the SW(software) number.
NCS Expert will tell you the level you already have by reading the the ECU(CiC) and will display CiC.Cxx(=Level) it allow only Coding not Programming.
If you don't know, better to show yours UiF(Inpa) and what region you are to have straigth the right file to Flash.

At least ++ a PSU is mandatory (Power Supply Unit) before Flashing.

---

What is the difference from this two? REMOTE:MOST_ASYNC or REMOTE:MOST_ASYNC _ab625
This is protocol used, ''_ab625'' is the last one, running with actual ICOM, if old one better to use it without if you don't know, do a search to know by reading your SW version in the iP of the ICOM.
And what is the name in NCSEXPER for Mostgw.

-> ?? NCS is for each whole ECU, not parts eg with WinKfp.

PS: Flashing 62 needs to Flash 63 BEFORE with sucessfull result.
A0 is the last to do and the longest one.

[Bimmer540]

PS: Flashing 62 needs to Flash 63 BEFORE with sucessfull result.
A0 is the last to do and the longest one.


So the order of flashing: 63, 62, A0.

And after Winkfp I mus code the ECU's with Ncsexper?

[Pi26]

PS: Flashing 62 needs to Flash 63 BEFORE with sucessfull result.
A0 is the last to do and the longest one.


So the order of flashing: 63, 62, A0.

And after Winkfp I mus code the ECU's with Ncsexper?

Yes for Both, if you change some FA/VO see according thread, usualy load expert/revtor Profile, your chassis, read CAS, then do FA_write job on CAS + FRM/NFRM, F6(back) then do SG_Codieren on CiC and TCU/Mulf/Combox first chosing the right ECU.
Didn't tell exactly your goal, just SW update ?

[Bimmer540]

TYPE: REMOTE
IP: YOUR IP
MODE: MOST_ASYNC
ICOM Lock

Must I config something in REMOTE.ini?

When I choose MOST_ASYNC I get no connection with Winkfp, only when I choose REMOTE?

[Jumper]

When do you have time for TeamViewer? PN

[Bimmer540]

When do you have time for TeamViewer? PN

CI63F1 is now programming with config REMOTE, but very slow. 21% in 6 hours?

[Jumper]

ICOM A1/A2 or NEXT?

[Bimmer540]

ICOM A1/A2 or NEXT?

NEXT

[Bimmer540]

[evaldazj]

If you using genuine NEXT and old icomB it won't work. I have tested few times, ir still programing through obd. For that I have my old a1 clone and allways succes. For genuine NEXT you need new icomB most adapter.