[BerlingoC5]

Hi

Do not know what I'm doing wrong.
Has switched BSI and Eeprom 95160 to BSI E01-00
Has found code from ECU

ECU
SAGEM
PSA - 9650825480
HOM-S2PM-382

1 can enter code 67HG to and "learn BSI" and code key.
2 When I enter the code for VIN No, it refuses to accept code.(67HG)
Have and tried and enter code to VIN first before I enter the code to learn BSI and code key.
But if I enter code 3114, it will take it.
And code 03114 This applies to VIN (not Key)

Get started car.
But getting Airbagg and ECU wrong

tried with another BSI but and create "virgin file" for BSI
Then I did not get the code 67HG and approve the key.
Are there any Eeprom in BSI one has to read or Ecu

[zmann]

When reading out code from the ECU (67HG) , did you swap the byte ? That's the nature of this type of ECU when reading 95080.

You have nothing to do with 03114, that is the security access code if to changing some config in BSI

[BerlingoC5]

When reading out code from the ECU (67HG) , did you swap the byte ? That's the nature of this type of ECU when reading 95080.

You have nothing to do with 03114, that is the security access code if to changing some config in BSI

Hi
Have tried and swaped byte and.
VIN accepts code 03114 or 3114 but not 67HG
and gets immo off with code 67HG
The car would start.

I do not get a programmed key unless I use other codes.
Uses the original key that was for the car and the BSI that failed (It got water inside it)