[autosolutions]

Hello does anyone have experince with Audi A5 2011 .

I think my wheel is a little stift to turn.

I tried a few other model they are much Better .

Oil is okay No bad sounds and No leaks or fault

Let me hear ur experince thanks

[apoelistas]

Two options
1. Retrofit Audi drive select kit (COMFORT, AUTO and DYNAMIC) and select comfort (new gear shift trim if radio concert, ADS switch, harness), then code with VCDs
2. Preselect with VCDs the comfort steering mode rather than auto.

Those sorted my audi B8 servotronic stiff steering while turning.

---

[quote="apoelistas" pid='371077' dateline='1536789653']
Two options
1. Retrofit Audi drive select kit (COMFORT, AUTO and DYNAMIC) and select comfort (new trim if radio concert, switch, harness)
2. Preselect with VCDs the comfort steering mode rather than auto.

Those sorted my audi B8 servotronic stiff steering while turning.

Try the second it is easier.

[MarcinOslo]

Maybe you don't have servotronic.
Which engine you have ?

[autosolutions]

Its a 2.0TFSI with 180hp

[MarcinOslo]

Then probably you don't have servotronic ,because for A5's under 200hp this has been as additional option ,not standard.

[apoelistas]

Coding for comfort steering wheel mode: Note Servotronic is 1N3 (PR code) Check if you have this. If you dont many have retrofitted this.

Enable Audi Drive Select
09 Central Electric
Byte 7 Bit 5 from 0 to 1 (enable ADS)
Byte 8 Bit 0 from 0 to 1 (sport mode enabled S automatic mode)
Byte 8 Bit 1 from 0 to 1 (servotronic steering)
Byte 8 Bit 2 from 0 to 1 (throttle response)
Byte 19: Bit 6 from 0 to 1 (enables ADS light on the control). Manual adjustment using counting method (dont enable this)

09 Central Electric then
Security 16
Adapt 10.
Set Channel 63 64 65 to 1 (comfort mode, all have to be the same)

This way comfort mode stays preselected indefinitely, rather than auto. (otherwise these values were set to 2 - auto)

After you are done you will be using ADS mode 1 (comfort) without having ADS. ADS just helps to change modes on on the console.


If you have MMi (GPS) you also have individual mode in addition you can select modes on the screen - add the following in addition:
Byte 17 ; Bit 7 change 0 to 1 (enable MMI display)
Adaptations:
[Security Access - 16] [Adaptation - 10] ; Channel 66 ; Change to 1

1 = Comfort
2 = Auto (Factory default)
3 = Dynamic - (Use this mode if you do not have MMI)
4 = Individual (Activates MMI "Individual" menu - Use this mode if you have MMI - GPS)