Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]

I need fuce atmega 16
19-09-2018, 07:35 AM,
Post: #1
I need fuce atmega 16
Hi. All

I need fuce bite atmega 16
And lock bite atmega 16

Red atmega 16 upa s orignal 

quartz in 8.000 H314

Thanks you lb


Attached Files Thumbnail(s)
       
Quote this message in a reply
19-09-2018, 07:50 AM,
Post: #2
RE: I need fuce atmega 16
(19-09-2018, 07:35 AM)Crysis05 Wrote:  Hi. All

I need fuce bite atmega 16
And lock bite atmega 16

Red atmega 16 upa s orignal 

quartz in 8.000 H314

Thanks you lb

Hello there are you trying to read atmega? Or program to run 8mhz crystal ?

Those fuse bytes all look locked out to me.

under If mine or others posts and info are helpful please give thanks/rep smile yes
Quote this message in a reply
19-09-2018, 07:54 AM,
Post: #3
RE: I need fuce atmega 16
Reading was performed successfully
  Problem writing
Quote this message in a reply
19-09-2018, 08:14 AM, (This post was last modified: 19-09-2018, 08:25 AM by dil6222.)
Post: #4
RE: I need fuce atmega 16
(19-09-2018, 07:54 AM)Crysis05 Wrote:  Reading was performed successfully
  Problem writing

Hmm I'd check that again as that chip looks locked i can tell because the fuses in your picture are all the same that's why it won,t write have you tried reading flash and eeprom?

Also be sure to erase first before programming and if you got all FF when reading flash or eeprom and you can't change any of the fuse or lock bits then chip is locked. smile but I'll help you unlock if that is the case depending on what fuses are programmed.

Do you have usbasp programmer ?

under If mine or others posts and info are helpful please give thanks/rep smile yes
Quote this message in a reply
19-09-2018, 08:31 AM,
Post: #5
RE: I need fuce atmega 16
Yes Read the flash and the iProm together
I scanned it

We have the programming again

Inflammation of the foliage 000
Quote this message in a reply
19-09-2018, 09:34 AM,
Post: #6
RE: I need fuce atmega 16
Is there anyone who would prefer that instead of me
http://eleccelerator.com/fusecalc/fuseca...=atmega16a
Quote this message in a reply
19-09-2018, 10:00 AM,
Post: #7
RE: I need fuce atmega 16
Ok what is this atmega from? 

And when do you get write error ? When trying to write flash/eeprom or writing lockbits?

under If mine or others posts and info are helpful please give thanks/rep smile yes
Quote this message in a reply
19-09-2018, 10:21 AM,
Post: #8
RE: I need fuce atmega 16
For all that is empty I want to write
When the check fades wrong
Quote this message in a reply


Forum Jump:


Users browsing this thread:
3 Guest(s)

Return to TopReturn to Content